JRC JMR-7210-6X - 18.14 Setting the Temporary Route Setting Values

18-29 Section 18 Setting up the Operation Mode
１
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
18.14 Setting the Temporary Route Setting
Values
Select [Temporary Route] in the classification pane.
In the setting dialog of the edit pane, perform the necessary setting relating to the temporary route.
Before starting automatic sailing, move own ship along the leg.
Setting Item Description of Setting Setting Value
Pre Run Speed Set a planned ship speed of the temporary route to
calculate the minimum leg length.
0.0 to 99.9 kn
Pre Run Time Set a planned time of the temporary route to calculate
the minimum leg length.
1.0 to 30.0 min
Pre Run Distance Set a planned distance of the temporary route. 0.10 to 9.99 NM
Enter Angle Set an entrance angle of the temporary route. 30.0 to 90.0°
Turning Radius Set an initial turn radius of the temporary route. 0.10 to 9.99 NM
Planned ROT Set the predicted value of ROT(Rate of Turn).
Calculated from Pre Run Speed and Turning Radius,
when entering the value of Planned ROT, the value of
Turning Radius is calculated and fluctuates.
It wil be changed
by the value of Pre
Run Speed.
XTD MAX Set the maximum XTD of the temporary route. 0.0 to 1.0 NM
Course Difference
Limit
Set the difference of the leg bearing of the predicted
course and ship's heading.
0.5 ~ 45.0°