EasyManua.ls Logo

JRC JSS-2150 - Terminating a Distress Alert

JRC JSS-2150
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CONFIGURATION AND SPECIFICATIONS
1-6
z DSC Watch Keeping Receiver.
Reception frequency Distress and safety frequencies of 2187.5 kHz and 8414.5 kHz, and
additionally on one or more of the 4207.5 kHz/ 6312.0 kHz/ 12577.0
kHz/ 16804.5 kHz
Receiving system Double superheterodyne
1st IF 40.04025 MHz
2nd IF 40.25 kHz
Frequency stability Within ±10 Hz
Sensitivity 1% or lower symbol error rate at reception input voltage of 1µV
Passband 6 dB bandwidth : 270 - 300 Hz
30 dB bandwidth : Within ±380 Hz
60 dB bandwidth : Within ±550 Hz
Spurious response Symbol error rate of 1% or better when an unwanted signal level of
31.6 mV is applied to a wanted signal level of 10 uv from an
intermediate frequency separated by 750 Hz or more through to a
frequency 3x the test frequency
Blocking/Desensitization Symbol error rate of 1% or better at a wanted signal level of 10 uV
and an unwanted signal level of 1 mV separated by 500 Hz
Conducted spurious emission Power emitted from antenna terminal is 2 nW or less.
Antenna impedance 50 unbalanced
z DSC Modem
Modulation rate
Within 100 baud ±3010
-6
Modulation method FSK (sub-carrier: 1700 Hz)
Mark frequency (Y) Transmission : Within 1615 Hz ±0.5 Hz
Reception (permissible value) : Within 1615 Hz ±20 Hz
Space frequency (B) Transmission : Within 1785 Hz ±0.5 Hz
Reception (permissible value) : Within 1785 Hz ±20 Hz
DSC protocol ITU-R recommendation M.493-11 (Class A and B)
DSC operation standards ITU-R recommendation M.541-9, M.821-1
DSC code 10-bit error detecting code
Message storage 20 messages for distress and 20 messages for others
z Antenna Tuner
Frequency range 1605.0 - 27500.0 kHz
Max. input power 1605.0 - 3999.9 kHz : 150Wpep
4000.0 - 27500.0 kHz : 200Wpep
SWR after tuning 2:1 or less
Tuning method Preset or auto-tuning
Tuning time Preset tuning: 0.5 sec, auto-tuning: max. 45 sec
Power supply 24 VDC (21.6 VDC to 31.2 VDC)
z Controller
Communication speed 57.6 kbps
Communication interface RS-485 and RS-232C, and Centronics compliant
Microphone input impedance 150 balanced
Standard modulation input -54 dBm
Audio output Internal loud speaker (8) : 5W max
External speaker impedance : 8 or more
Handset phone (150) : Rated 1mW or more
LCD display 3.8 inch FSTN monochrome, 320 x 240 dot, LED backlight

Table of Contents

Other manuals for JRC JSS-2150

Related product manuals