JRC JSS-2150 - Page 33

INSTALLATIONS
2-9
5. Fix the bottom part to the surface of the wall or floor with the 4 screws (M5).
Bottom part
Screw(4-M5)
EXTENSION BOARD
TERMINAL BOARD
Terminal block
6. Loosen one screw (M4) to remove the cable holder. Then connect the power cable to the
terminal block and fix it with a nylon band. Connect the armored wire to the TERMINAL and
EXTENSION BOARD and fix it with a nylon band.
View from arrow A
Fix with nylon band
Cable holder
Power cable
A
rmored
wire
Screw