INSTALLATIONS
2-18
2.2.1.3 Connecting the power cable
Make sure the transceiver's power is turned off at the breaker and the power supply is off before
connecting the power (DC24V) to the transceiver as shown below.
Note: Wire the power cables and signal lines before installing the upper part.
① When the bottom part installation is completed,
remove the cable holder from the power cable hole
next to the breaker.
② Insert the power cable through the back panel into the
terminal board and use a Philips head screwdriver to
tighten the cable to the terminal. Be careful of the
terminal board's polarity ([-] [+] from the left) at
this time.
③ Replace the cable holder on the power cable.
Philips screwdriver
To Next Page
Loading...
