INSTALLATIONS
2-33
2.2.4.3 Connecting the signal lines
Use the following method to connect the signal lines to terminals TB1 - 2, TB 11 - 12, and TB21 - 22 on
the CQD-2250 connection board in the connection box.
Note: Connections on the terminal board of the transceiver are the same.
① Slide a thin flathead screwdriver all the way into the
slit as shown in the figure at the right and then insert
the signal line*.
*) Compatible wire sizes: 0.2 - 2.5 mm
2
(AWG 24~12)
Stripped length: 8 mm
② Remove the screwdriver and make sure that the
signal line is securely connected.
③ When the wiring is finished, secure the cables in a
bundle with the cable clamp.
信号線挿入口
スリット
マイナスドライバ
Signal line port
Flathead screwdriver
Slit
Nylon band
To Next Page
Loading...
