INSTALLATIONS
2-41
2.2.5.4 Wiring the control signal lines
(1) Antenna tuner terminal
Use a flathead screwdriver to connect the signal lines as shown below.
① Loosen the screw with the screwdriver.
② Insert the control signal line.
(Compatible wire sizes: 0.1 ~ 1.5 mm
2
(AWG 30~14), stripped length: 6 mm)
③ Tighten the screw with the screwdriver to fix the signal line.
123456
TB202
CONTROL GND
銅板
幅： 50mm以上
厚さ： 0.4mm以上
TB2
RF GND
TB1
RF IN
TB201
7 8
Width: 50 mm or more
Thickness: 0.4 mm or more
Copper plate
To Next Page
Loading...
