JRC JSS-2150 - Setting the Inactivity Timer (for Menu Shutdown); Setting the Reference Value for the Channel Auto Search

Settings & Registrations
5-9
5.3.6 Setting the inactivity timer (for menu shutdown)
To close menus of the controller automatically which is left as opening menus, the inactivity timer
can be set according to the following procedure.
■ Procedure ■
1
1
1
.
.
.
Press the MENU key, and through
hierarchical menus, select 7.3 My
controller.
2
2
2
.
.
.
Move the cursor to 6. Menu shutdown
with the numeric keypad or jog dial, and
press ENT.
3
3
3
.
.
.
Input the timer value and press ENT.
 The range is from 00 to 60 minutes.
 To set this timer to OFF, input 00.
In this case, the screen shows OFF as
shown at right.
5.3.7 Setting the reference value for the channel auto search
When making a DSC routine call, the controller searches the working channel (frequency)
automatically by checking the every channel busy referring the signal level with the value set as
follows.
■ Procedure ■
1
1
1
.
.
.
Press the MENU key, and through
hierarchical menus, select 7.3 My
controller.
2
2
2
.
.
.
Move the cursor to 7. CH search ref with
the numeric keypad or jog dial, and
press ENT.
3
3
3
.
.
.
Input the reference value and press ENT.
The range is from 00 to 50.
7.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Tx meter :PWR
5.Data transfer
6.Menu shutdown :OFF
7.CH search ref :40
8.Frequency digits :7 only
7.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Tx meter :PWR
5.Data transfer
6.Menu shutdown :10min
7.CH search ref :40
8.Frequency digits :7 only
7.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Tx meter :PWR
5.Data transfer
6.Menu shutdown :10min
7.CH search ref :40
8.Frequency digits :7 only
7.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Tx meter :PWR
5.Data transfer
6.Menu shutdown :OFF
7.CH search ref :45
8.Frequency digits :7 only