JRC JSS-2150 - Setting Connections for Options

Settings & Registrations
5-17
5.6 Setting connections for options
When setting connections between the controller and optional devices, such as a printer,
configure the conditions as appropriate according to the device type, as follows.
■ Procedure ■
1
1
1
.
.
.
Press the MENU key, and through
hierarchical menus, select 7.6 Option.
2
2
2
.
.
.
Move the cursor to the desired item, and
press ENT.
Move the cursor to the right. Then select
the condition as appropriate and press ENT.
- The content and the selectable conditions of each item are as follows.
Item Name Content
Selectable conditions
( : Factory default)
Connection Connection status and printer type
None/CMD/ Serial PRN /
NKG-800 / DTE
Data out Printing method for DSC messages ---/ Auto/ Manual
Baudrate Transmission speed to printer ---/ 4.8k/ 9.6k/ 38.4k/ 57.6kbps
Flow control Handshake setting with printer ---/ None/ Hard
Print direction Printing sequence of lines ---/ Upright/ Invert
- When connecting a serial printer (e.g. NKG-91/901), set the items as follows:
1.Connection :Serial PRN
2.Data out :Auto
3.Baudrate :4.8k
4.Flow control :Hard
5.Print direction :Invert (NKG-91/901)/Upright (DPU-414)
- When connecting the NKG-800/900 printer, set the items as follows:
1.Connection :NKG-800
2.Data out :Auto
- If no option is connected, select None/CMD at the Connection.
Note) When None/CMD is set, connect nothing to the serial port.
- When connecting the data terminal to the controller for the telex communication,
set Connection item to DTE. Note that restart the system just after this setting.
Moreover, Baudrate, Flow control and Print direction become unchangeable in
this case.
Note
7.6)Option
1.Connection :None/CMD
2.Data out :---
3.Baudrate :---
4.Flow control :---
5.Print direction :---
0.Back
7.6)Option
1.Connection :None/CMD
2.Data out :---
3.Baudrate :---
4.Flow control :---
5.Print direction :---
0.Back