JRC JSS-2150 - Turning off the Power; Putting into Sleep Mode

Operation
4-7
4.2.2 Turning off the power/ Putting into sleep mode
CAUTION
When completely turning off the power to the equipment, turn off the breaker
on the transceiver
■ Procedure ■
Press the key and DIM key
simultaneously.
After that, the power-off process is activated
according to the controllers' status.
 When using only one controller
Select the desired item below on the
popup screen shown at right
 [OK]: Turns off the power. (Puts into
sleep (energy saving) mode.)
 [Cancel]: Returns to the previous screen.
 When using two controllers
On a controller with access rights, select
the desired item below on the popup
screen shown at right
 [EQP]: Turns off the power. (Puts into
sleep (energy saving) mode.)
 [CTRL]: Puts the controller into sleep
mode and gives access rights
to another controller.
 [Cancel]: Returns to the previous screen.
On a controller without access rights,
select the desired item below on
the
displayed popup screen at right
 [OK]: Puts one controller into sleep
mode.
 [Cancel]: Returns to the previous screen.
 In sleep mode, the equipment changes to the following statuses.
 If all the equipment goes to sleep, the ALM lamp lights green to indicate
the DSC watch keeping receiver is on and operating.
 The POWER lamp blinks in the data terminal.
 If a distress or urgent DSC message is received, the equipment
automatically turns on and sounds an alert.
 Turn off both the AC and DC breakers if turning off the power at an external
NBD-2150 AC/DC Power supply.
TEL ITU- 401
4357.00
4065.00
RX kHz
TX kHz
DUP
WKR scan bands:
2 4 6 8 12 16MHz
ID 431001234 23:59(UTC)
Pos 89ﾟ59.0123'N
179ﾟ59.6789'E@23:59
SIG
12 -S N2
NonDST: +
DROBOS: +
EdtDST: +
M ENU
M ENU
1
2
3
M ENU
G PS
OK to sleep this
controller?
[Cancel]
[ OK ]
TEL ITU- 401
4357.00
4065.00
RX kHz
TX kHz
D UP
WKR scan bands:
2 4 6 8 12 16MHz
ID 431001234 23:59(UTC)
Pos 89ﾟ59.0123'N
179ﾟ59.6789'E@23:59
SIG
12 -S N2
NonDST: +
DROBOS: +
EdtDST: +
M ENU
M ENU
1
2
3
M ENU
G PS
OK to sleep the MF/HF
equipment, or
only this controller?
[EQP] [CTRL] [Cancel]
[EQP]
TEL ITU- 401
4357.00
4065.00
RX kHz
TX kHz
D UP
WKR scan bands:
2 4 6 8 12 16MHz
ID 431001234 23:59(UTC)
Pos 89ﾟ59.0123'N
179ﾟ59.6789'E@23:59
SIG
12 -S N2
NonDST: +
DROBOS: +
EdtDST: +
M ENU
M ENU
1
2
3
M ENU
G PS
OK to sleep the
MF/HF equipment?
[ OK ] [Cancel]
[ OK ]
Note
PWR
CONT