JRC JSS-2500 - Receiving Safety or Urgency Area Calls

Operation
4-45
4.5.4 Receiving safety or urgency area calls
■ Procedure ■
After pressing the ENT button to close the
BAM alert display, the screen at right is
displayed, and the ALM lamp blinks and the
alert grows louder gradually.
If no procedure exists, starts operating the
received message, i.e. the specified working
frequency is set automatically. Then press
CANCEL to silence alert and listen to the
broadcasting.
- When receiving the area call where the FEC is specified, the telex mode is set
to the equipment. Then receive the telex broadcasting with the data terminal.
- To check the topic when receiving an urgency area call, select INF menu to
view the detail of the message.
- If menu 7.5.9 Auto FREQ change is setting to OFF, when pressing the
CANCEL key, the popup is displayed on the screen. In this case select either
Accept or Ignore. (For details, see 5.5.8)
Note
TXTO : Area
|
DSC
ID 431001234 : +
Pos 89ﾟ59 .0123'N
179ﾟ59 .6789'E@23:59
S
IG
RX 2187.50 kHz
TX 2187.50 kHz
W KR 2 4 6 8 12 16
A
SAF ARE
TE L : Rx ----- .-- / Tx 2182 .00 KHz
[RTLY ][ INF ][ HLD ][ END ]
|
SAF
Call-F : Rx 2187 .50 / Tx 2187 .50 KHz
Waiting for CH free
G PS
9
C M ENU A