JRC JSS-2500 - Own Ship Position and Time Settings

Settings & Registrations
5-3
5.2 Own ship position and time settings
Normally, the ship's position and the time are updated automatically if importing GPS information.
But, if necessary, input these parameters manually as follows.
CAUTION
The time in the 7.2 POS/TIME menu means the time when the position
information is valid, and is different from the present time mentioned in the
7.1 Date & time menu.
■ Procedure ■
1
1
1
.
.
.
Press the MENU key, and through
hierarchical menus, select 7.2
POS/TIME.
2
2
2
.
.
.
To input your own ship's position, press
ENT.
Select the position quadrant with the jog dial,
and press ENT. Then input the latitude and
longitude with the numeric keypad or jog dial,
and press ENT.
3
3
3
.
.
.
When completing the input of the ship’s
position, the cursor moves to the time
column of the 2. UTC of position.
 Input the hours and minutes with the
numeric keypad or jog dial, and press ENT.
 Just after inputting the position, the
present time is input to this column
automatically.
 To close this menu after completing the
setting, press the CANCEL key.
- After the position and the time information are input manually, that information
is not overwritten with an external device, such as a GPS, automatically.
- If using the GPS information after manually inputting data, set the quadrant
field mentioned above to “GPS”.
- If the position and the time information are not received, from a GPS or other
device within 1 minutes after powering on, or after 10 minutes has elapsed
since the external input was interrupted, the BAM alert may appear. Further,
after manual input, if the position and the time are not updated within 4 hours
since the last entry, the BAM alert appears.
7.2)POS/TIME
1.Own position:NE
89°59.1234'N
179°59.1234'E
2.UTC of position:
23:59
3.State display:Normal
4.Position source set
0.Back
1.Own position
7.2)POS/TIME
1.Own position:NE
89°59.1234'N
179°59.1234'E
2.UTC of position:
23:59
3.State display:Normal
4.Position source set
0.Back
NE
7.2)POS/TIME
1.Own position:NE
89°59.1234'N
179°59.1234'E
2.UTC of position:
23:59
3.State display:Normal
4.Position source set
0.Back
23
Note