JRC JSS-296 - Page 185

Jan 8, 2005
- 6 -
OFF
ON
24V(+)
24V(+)
BATT
Connect to the DC
Terminal No.3-No.6
Circuit Tester
24V(+)
24V(+)
BATT
Imsulate terminals with vinyl tape.
Connect to the DC
Terminal No.3-No.6
(16) Check the Breaker connection as the following table shows.
Breaker
Between 24V(+)
terminals
Between 24V(-)
terminals
ON Short Short
OFF Open Open
Note: Turn off the Breaker after checking.
(17) Turn off the Breaker and insulate Breaker terminals with vinyl tape.
(18) Fix the Bracket two M4 X 10-screws (with SW) to the upper left of the front panel
and not use screw hole (M5) as shown below.
Screw hole
for Bracket
fixing
Unused
screw hole
Bracket
Bracket
(
front elevation)