4-77
(8) SPD
21. Press
"SPD".
22. Press to select "OFF" or "RANGE", and press
.
23. Enter the speed with the numeric keypad, and press
.
OVER: An alarm will sound when the speed exceeds the set value.
UNDER: An alarm will sound when the speed falls below the set value.
IN RANGE: An alarm will sound when the speed is within the set range.
OUT RANGE: An alarm will sound when the speed is outside the set range.
4.11.2 Setting Alarm Sounds
· Individual alarm sounds can be set for each item.
· If the alarm is set to "OFF" in the alarm settings, the alarm sound cannot be set, but even if the
alarm is set to "ON", the alarm sound itself can be set to "OFF". In that case, when the alarm
occurs, no alarm sound will play, but a blinking alarm icon will appear.
· When an alarm sound is set, the "♪" icon will appear on the alarm screen.
· You can preview the alarm sound when setting it.
· Please refer to "4.20 Equipment Configuration" and switch the unit to equipment configuration
mode.
1. Press
, , and then to display the alarm sound screen.
Only items whose alarms have been set will be displayed.
2. Select the alarm you wish to set with the numeric keypad.
3. Press to select the alarm sound, and then press
.
The following will be displayed. Press
to hear the alarm sound.
Press
again to stop the alarm sound.
Set alarm sound
Play alarm sound with
Procedure
To Next Page
Loading...
