4-78
4.12 Navigation Assistance
4.12.1 Measuring the Trip Distance and Time During Navigation (Navigation
Assistance 1)
· Navigation Assistance 1 shows the time when measurement started, the time measurement
ended, the total time, and the total distance over ground. If the speed through water is input
from external equipment, the distance through water is also displayed.
· When measurement is started, the time that measurement was started is displayed, and the
total time and total distance will gradually increase.
· When measurement is stopped, the time that measurement was stopped is displayed, as well
as the total time and total distance.
· To start measurement, start navigation, or start measurement from the Navigation Assistance 1
screen.
· Stop measurement from the Navigation Assistance 1 screen.
· Measurement does not stop even if navigation is stopped. This allows total time and distance
to be measured even when routes are changed during navigation.
Navigation Assistance 1 Screen
(Refer to "3.1.9 Navigation Assistance Screen" for screen details)
(1) Starting Measurement
1. Press
several times to display the Navigation Assistance screen.
2. Press several times to display the Navigation Assistance 1 screen.
3. The cursor will move to "NAV START/END", so press
.
(2) Ending Measurement
1. Press
several times to display the Navigation Assistance screen.
2. Press several times to display the Navigation Assistance 1 screen.
3. The cursor will move to "NAV START/END", so press
.
· Measurement starts automatically when navigation is started.
· In order to perform distance through water, speed through water must be input from
externally connected equipment.
Memo
Procedure
To Next Page
Loading...
