4-84
4.14.5 Input Assistance Settings
· Input assistance display can be turned on or off.
ON: Input assistance display enabled
OFF: Input assistance display disabled
1. Press
, , and then to select "INPUT ASSIST".
2. Press to select "ON" or "OFF", and press
.
4.14.6 Selecting the Display Screen
· You can select which screen is displayed.
· Set screens which you wish to display to "ON", and screens which you do not wish to display to
"OFF".
· You can set the navigation information , PLOT1, PLOT2, PLOT3, CDI, or GPS information
screens to be displayed when the unit is started. Set the screen you wish to display on startup
to "START".
· Only one screen can be set to "START". To change the "START" screen, change the value of
the currently set "START" screen to something other than "START" before setting the new
"START" screen.
1. Press
, , and then to select "DISPLAY SELECT".
2. Enter the number of the screen you wish to set with the numeric keypad.
4. Press to select "START", "OFF", or "ON", and press
.
Procedure
Procedure
To Next Page
Loading...
