JRC NWZ-4740 - Setting the Time Display; Setting the Geodetic System; Setting Distance and Speed Units; Setting Height and Depth Units

4-86
4.15.3 Setting the Time Display
· You can select 24 hour or 12 hour time display.
· Please refer to "4.20 Equipment Configuration" and switch the unit to equipment configuration
mode.
1. Press
, , and then to select "TIME DISP".
2. Select the display format with , and press
.
4.15.4 Setting the Geodetic System
· You can select the geodetic system to use.
· You can choose between 46 types of geodetic systems. Please refer to "Appendix 1 Geodetic
Systems" for details.
· Please refer to "4.20 Equipment Configuration" and switch the unit to equipment configuration
mode.
1. Press
, , and then to select "DATUM".
2. Select the geodetic system with , and press
.
4.15.5 Setting Distance and Speed Units
You can select "NM, kn", "km, km/h", or "mi, mi/h" for distance and speed units.
Please refer to "4.20 Equipment Configuration" and switch the unit to equipment configuration
mode.
1. Press
, , and then to select "UNIT - DIST/SPEED".
2. Select the units with , and press
.
4.15.6 Setting Height and Depth Units
· You can select m, ft, or fm for height and depth units.
· If you select fm, enter the conversion value from "m". The default value is 1 fm = 1.8288 m.
· Please refer to "4.20 Equipment Configuration" and switch the unit to equipment configuration
mode.
1. Press
, , and then to select "HEIGHT/DEPTH".
2. Select the units with , and press
.
If you select fm, you must enter the conversion value from "m".
3. Press to select "SET", enter the conversion value with the numeric keypad, and
press
.
Procedure
Procedure
Procedure
Procedure