4-101
4.20.3 Setting Sensor Position / CCRP
· You can set the ship size, CCRP position, and GPS sensor position.
· The CCRP position and GPS position are set on a coordinate system with the center of the
ship as the point where the axes cross.
· Set the ship size (ship length and width), and set the CCRP position and GPS sensor position.
· The set CCRP position can be output to externally connected equipment. For output, refer to
"4.20.7 Data I/O Settings ", and select "CCRP" as the output sentence.
To output to external equipment, the equipment must have CCRP send / receive functionality.
· CCRP cannot be set from a sub-display. Set CCRP from the main display.
The CCRP position can be received. If the set position and received position differ, the
following alert will occur, so please perform the settings again. A "*" will appear on the status
bar until the settings have been redone.
1. Refer to "4.20 Equipment Configuration" and display the equipment configuration menu.
2. Press
"CCRP" to display the CCRP settings screen.
3. Press
"SHIP".
4. Press to set the value to "ENABLE", and press
.
5. Select the ship width and length, enter the values with the numeric keypad, and press
.
6. The SENSOR and CCRP x and y values are set in the same way.
·
If the sensor position does not fit within the ship, the sensor position will change to
"DISABLE". Perform settings again such that the position is within the ship, and
change the setting to "ENABLE". The same is true for the CCRP position.
Memo
Procedure
To Next Page
Loading...
