4-105
4.20.7 Data I/O Settings
· You can confirm settings for connection with external connected equipment.
· Data input and output data consists of serial data, contact data, and LAN data.
· Output sentences, bit rate, and output intervals can be set for each port. However, some
combinations of bit rates, intervals, and numbers of sentences cannot be made. In this case,
set the sentence to the minimum needed value.
･ To connect a Current, Temperature and Depth meter, use a input port in DATA IN/OUT4.
· The following is an overview of the serial data.
NMEA: NMEA format data output.
IEC: IEC format data output.
JRC: JRC format data output. Fixed at 1200 bps.
ROUTE: Output or input of memory route and waypoint data.
Route and waypoint data can be sent to / from externally connected
computers and equipment.
SWITCH: Outputs automatic switch (NCZ-1537A) control data.
PRINTER: Outputs printer formatted data (Data IN/OUT1 only).
EXT EQUIP: Input configuration for tidal current meter (Data IN/OUT4 only).
· The following is an overview of contact data.
SYSTEM: A contact is made when the positioning stopped alarm occurs.
SYS+XTD+ARV: Generates contact when positioning is not performed, when entering or
leaving a route, or when arriving at or departing from a waypoint.
The XTD / Boundary and Arrival / Anchor alarms are those set in "4.11
Alarm Settings".
200p/NM: 200 pulse/NM LOG pulse is output.
400p/NM: 400 pulse/NM LOG pulse is output.
ALARM ACK: Acknowledgment output for externally input alarm.
· The following is an overview of the LAN data.
ACTIVE ROUTE: The current active route is shared with other equipment.
DATA ROUTE: Route(s) in memory are shared with other equipment.
DATA OUT: NMEA and/or IEC data output is performed.
MUTUAL: Mutual monitoring is performed when two of this unit are connected.
When GPS positioning is not being performed, the GPS positioning
information from other units can be used.
REMOTE MAINTE: Remote maintenance data output is performed.
To Next Page
Loading...
