4-106
4.20.7.1 Configuring Data IN/OUT1
· NMEA, JRC, IEC, route WPT, automatic switch control data, and printer data can be output via
data IN/OUT1.
· To connect a DPU-414 printer, use a D-sub9 pin connector.
1. Refer to "4.20 Equipment Configuration" and display the equipment configuration menu.
2. Press
, and then , and select "DATA IN/OUT1".
3. Select the data type with
and press .
(1) When "NMEA" is Selected
Select the version, bit rate, output sentence, and interval.
Sentence and Interval Setting Screen
If no sentence is displayed, the output sentence has not been selected.
4.
Press "SENTENCE".
5. Move the cursor to the sentence you wish to output, and press
.
6. The output interval is displayed. Select the interval and press
.
Procedure
The selected sentence is displayed.
If no sentence has been selected, no
sentence is displayed.
To Next Page
Loading...
