JRC NWZ-4740 - Installation of the Sensor on the Mast

6-3
6.1.3 Installation of the Sensor on the Mast
Use a screw adapter (optional component or equivalent) to connect the sensor to the mast.
The diagram shows the JLR-4341, but these instructions apply equally to the JLR-4340 as well.
1. Loosen the fitting belt screw
with a screwdriver to remove
the clamp.
2. Coil the fitting belt around
the mast as shown below.
3. Tighten the clamp screw with
the screwdriver.
How to Install the Sensor on the Mast
Screw Adapter
MTV302007A
JLR-4341
DGPS Sensor
Fitting Belt
MPBP02520
Mast (
φ
26 to
φ
90 supported)
Clamp Band
Clamp
Flathead Screwdriver