JRC NWZ-4740 - 4.3 Plot Screen Operation

4-10
4.3 Plot Screen Operation
4.3.1 Cursor Operation
4.3.1.1 Displaying the Cursor
· Cursor display can be turned off and on.
· When the cursor is displayed, cursor information (cursor latitude and longitude, bearing and
distance from ship to cursor) will be shown on the top right of the screen.
1. Press the
key on the plot screen to display the cursor.
2. To hide the cursor, press the
key again.
To automatically hide cursor information when the cursor has not moved for 10 seconds, set
"CURSOR INFO" to "OFF" as directed in "4.3.12 Hiding Plot Screen Symbols". Set it to "ON"
to always display cursor information.
4.3.1.2 Moving the Cursor
· The cursor can be moved up, down, left, right, and diagonally.
1. Use to move the cursor up, down, left, and right.
Press , , , or simultaneously to move the cursor
diagonally. Holding the buttons down will cause the screen to accelerate while continuing its
movement.
Cursor
Cursor Information
Cursor Latitude and Longitude
Distance from Own ship to Cursor
Bearing from Own ship to Cursor
Own ship
Procedure
Procedure