104
Section 3 Operation
USE THE PC
•Select USE THE PC to display the MEMORY COPY - PC menu.
Notes:
•To use this function, it is necessary to install the communication tool
exclusive for the PC. This communication tool is not attached to the
RADAR 1800. Please download it from our Internet site. (URL is found
on the backside of the manual). This communication tool is free.
•Use an RS-232C cable (9-pin cross type) sold commercially to connect the
RADAR 1800 and the PC. (Refer to p.40)
• This function cannot be used while Navigation is active.
Transferring data to a PC
You can upload data from the RADAR 1800 to PC.
Follow the procedure described below.
Refer to the manual attached to the communication tool for
detailed information about how to operate the communication tool.
q Set the PC communication tool to the reception status.
w Select RADAR1800 > PC and press
Joystick
.
The data select menu appears.
e Select the data to send and press
Joystick
to start transmmision..
r When the transmission is completed, the message “COMPLETE!”
appears.
Note:
•If the transmission is terminated due to the line failure, the message
“ERROR!” appears. In this case check again whether the cable is broken, a
proper cable is used, and so on.
Receiving data from a PC
You can download data from the PC to the RADAR 1800.
Follow the procedure deseribed below.
Refer to the manual attached to the communication tool for
detailed information about how to operate the communication tool.
q Select PC > RADAR1800 and press
Joystick
.
The RADAR 1800 gets ready to receive data from the PC.
The RADAR 1800 enters the standby mode during transmission.
w After selecting the data to send using the communcation tool, start
transmission.
e When reception of data from the PC is completed, the message
“COMPLETE!” appears.
To abort reception, press and hold
BR
To Next Page
Loading...
