75
Section 3 Operation
PLANNED ROUTE (Navigating according to a
planned route)
• Select PLANNED ROUTE to display the ROUTE LIST screen and
two Soft Keys
NEW
ROUTE
and
ALL
ERASE
.
• Select a route and press the
Joystick
to start the navigation by the
selected route.
• To make registration of a new route, press the
NEW
ROUTE
. (Refer to
“Storing a new Route” p.83)
• To delete all registrations, press the
ALL
ERASE
. (Refer to “Erasing all
routes” p.84)
TEMPORARY ROUTE (Navigating according to a
temporary route)
Select TEMPORARY ROUTE to enter the Temporary Route
Mode. And press
TEMP
ROUTE
key to enter the mode directly.
Create a temporary route in the chart and start the navigation along the
route. The following four soft keys appear.
ALL
ERASE
Erasing all temporary waypoints.
If you erase one waypoint then point the one and push
Joystick
.
MOVE
Moving a waypoint that pointed by cursor.
1. Point the waypoint by cursor and press this key.
2. Move cursor to desire position and press
Joystick
.
INS
Inserting a new waypoint into created temporary route.
1. Point the waypoint of Leg (: A part of route) that
inserts it by cursor.
2. Press this key.
3. Move cursor to desire position and press
Joystick
.
FINISH
Finish making a temporary route.
Planning a temporary route and starting navigation
• You can make a temporary route consisting of waypoints specified
arbitrarily and temporarily. The temporary route is not stored in the
list unless you purposely do so.
• Specify a waypoint in the chart as the start point by pressing
Joystick
to move the cross cursor and pushing it. Do the same procedure to
specify temporal waypoints you want to go. You can specify up to 100
waypoints in a route. After specifying all waypoints you want to go,
press
FINISH
key. Two soft keys
START
NAV
and
MEMORY
are displayed.
• Press the
START
NAV
key to display the START NAVIGATION popup,
select YES and press Joystick then begin the navigation.
To Next Page
Loading...
