JRC RADAR 1800 - NEAREST PORT (Searching for and navigating to a nearest port); PREVIOUS MOB (Setting a waypoint to the MOB); SEQUENCE (Selecting the order of waypoint navigation)

76
Section 3 Operation
MEMORY FULL!
CANNOT REGISTER
THE ROUTE.
ERASE ANY
REGISTRY.
• Press the
START
NAV
Soft Key to display the START NAVIGATION
popup menu, after confirmation the specified waypoints are
connected to each other by lines to begin the navigation.
CANCEL FINISH ZOOM
IN
ZOOM
OUT
POINT THE CURSOR TO THE
DESIRED WAYPOINT POSITION
AND PRESS THE JOYSTICK.
TEMPORARY ROUTE
1
Start point
2
End point
3
Relay points
Storing the temporary route to the List
• Press
MEMORY
key to display the NEW ROUTE popup in which you
can store the route.
• Enter a name (up to eight characters) and a comment (up to 23
characters) and press
Joystick
.
• If the memory for the route or the waypoints is not enough, the
MEMORY FULL message disappears.
Press any key or wait about seven seconds to delete the message.
NEW ROUTE
NO. 0
ROUTE 0
____________
___________