JRC RADAR 1800 - BEARING

88
Section 3 Operation
Menu Operations
General
Following the basic operations described below, you can easily
perform all menu operations using only the
Joystick
.
Selecting an item:
•Press the
Joystick
up or down to select an item and push it to
complete the selection. When you select a normal item, the pull-down
menu of the selected item opens. Select an item with the >> mark to
display the submenu in the next hierarchy.
Changing settings
•When settings are specified by numerical values, press the
Joystick
up or down to change the values. When settings are specified by bar
chart or by other items, press the
Joystick
to the left or right to
change the settings.
Entering changes
•Push the
Joystick
to enter the change. If you want to cancel the
change, push
BR
BR
T/CLR
T/CLR
before completing it.
Top Menu
You can display the Top Menu by pressing the
MENU
MENU
key.
Pressing the
MENU
MENU
again or
BR
BR
T/CLR
T/CLR
, the menu closes.
RADAR SETTING
•Press
MENU
MENU
, select the “RADAR SETTING>” item and push the
joystick, the “RADAR SETTING” menu is displayed.
RINGS
The range rings can be turned to on or off via this menu.
(Refer to “RINGS” p.61)
MENU
RADAR SETTING >
PLOT SETTING >
GRAPH SETTING >
GPS SETTING >
DGPS SETTING >
WAAS SETTING >
INSTALLATION >
CUSTOM SETUP >
MEMORY COPY >
ALARM SETTING >
EDIT >
RINGS
BEARING
INTERFERENCE
SEA
TUNE
EXPANDER
PROCESS
TRAILS
TX-PLAN >
WAYPOINT
COLOR >
RADAR SETTING
ON
HUP
ON
MANUAL
AUTO
OFF
OFF
OFF
OFF