– 49 –
9. Folder types
1. Select an optimal folder according to nature, thinness, and
thickness of the material cloth.
(Caution) The – line (minus line) in the JUKI Part Numbers
denotes a part for which Part No. setup is not
finished at the Parts Center.
(Acceptable at the time of ordering)
No JUKI part No.: Folder asm./Product name
Outlet dimensions
Folder features
1 24502502 23420AY18-1/8 3.2mm
2 23420AY18-1/16 1.6mm
3 24648503 23420AY18-3/32 2.4mm
4 24683302 23420AY18-5/32 4.0mm
5 24503005 23420Z-9-1/8 3.2mm
6 23420DC9 3.2mm
A standard type provided with a spring, suitable
for a product that has step sections in the
material cloth. (Stanadard)
Same as the standard type. The outlet section
at the folder tip is narrow, and suitable for thin
materials.
Same as the standard type. The outlet section
at the folder tip is narrow, and suitable for
medium-weight materials.
Same as the standard type. The outlet section
at the folder tip is wide, and suitable for extra-
heavyweight materials.
The folder tip section is shorter than that of the
standard type. Functionally same. A shorter type
assures easier control of materials.
This is a fixed folder without a spring. Deviation
is minimal as a result of too much pressing of
the material.
Outlet
Inlet
Folder asm.
To Next Page
Loading...
