– 6 –
3-5. Installing the thread stand
1) Assemble the thread stand, and put it in the hole in the top left corner of the machine table.
2) Tighten locknut
to x the thread stand.
3) When ceiling wiring is possible, pass the power cord through spool rest rod
.
3-6. Raising the machine head
WARNING :
Tilt/raise the sewing machine head with both hands taking care not to allow your ngers to be
caught in the head.
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of
the sewing machine.
This sewing machine cannot be raised unless the throat plate auxiliary cover (asm.) is removed.
Raise the sewing machine after removing the throat plate auxiliary cover (asm.) referring to
"I-3-3. In-
stalling the throat plate auxiliary cover" p.4
.
When using the sewing machine, install the throat plate auxiliary cover (asm.) referring to
"I-3-3. Installing the throat plate auxiliary cover" p.4
.
1. To prevent the sewing machine from falling, be sure to raise the machine head after xing
table/stand (casters) at the leveled place so as to prevent it from moving.
2. Be sure to raise the machine after shifting feeding frame
to the rightmost position
since X-feed cover
interferes with the machine table causing breakage.
3. When the machine is raised, clean portion
of the bottom face of the machine to pre-
vent the surface of the machine table from being stained with oil.
The intermediate
thread guide
To Next Page
Loading...
Need help?
General
