JUKI APW-895/IP-420 - Assembling the Thread Stand and Attaching it to the Machine; Installing SP-46 (Clamp Bar Stacker)

− 7 −
7. INSTALLING SP-46 (CLAMP BAR STACKER)
(OPTIONAL PART NO. : 40058952)
Clamp bar stacker is delivered in the state
that it is xed in the frame at the time
of delivery with the clamp bar stacker
mounted. It is necessary to change the
installing position to the normal using
position.
1
Remove stacker xing plate
1
.
2
Turn the whole stacker in the direction of the
arrow and take it out from inside of the frame.
3
Change stacker turning shaft
A
section to
stacker base hole
B
.
At this time, take care to prevent the stacker cord, the air piping, etc. from being caught.
4
Lock the whole stacker with hinge
2
.
5
Enter safety bar
3
from
C
and
D
directions
and x it at the position where is almost
parallel to the oor.
At this time, conrm that air is being
supplied.
C
D
3
2
1
A
B
6. ASSEMBLING THE THREAD STAND AND ATTACHING IT TO
THE MACHINE
Putting nut and washer between main unit frame
1
and x the thread stand as illustrated in the left-
hand gure.
Washer
Spring washer
Nut
1