JUKI DDL-9000C-FMS - Function of Formatting the USB Device; Ddl-9000 C-S

When you save data to a USB memory, save it according to the following folder structure. When data is not
being saved to the right folder, it is not possible to write data in a panel from a USB memory.
※[…]: Folder name
Media
[DDL-9000C]
[VDATA]
[prog]
DDL00 XXX .EPD
DDL00 XXX .MSW
DDL00 XXX .MSP
VD00 XXX .VDT
[DDL-9000C]
[MT RVL (6 digits)]
[SP RVL (6digits)]
MT RVL(6 digits) .P01
SP RVL(6 digits) .P00
MT RVL(6 digits) .HED
SP RVL(6 digits) .HED
(5) Function of formatting the USB device
It is possible to format the USB device.
(Caution) Before you format the USB device, save necessary data stored in the device to other me-
dia. When you format the USB device, data stored in the device is erased.
① Select the function of formatting the
USB device.
1. When you hold down the ❾ for
three seconds on the sewing screen,
a mode screen for the serviceperson 1
level is displayed.
2. After you press the ❶ and
select "10 USB format," press the
❺ to display the selection screen of a
check program.
❶
❺
❻
❺
❶
❾
② Execute or cancel the format of the
USB device.
1. When you press the ❺ button,
the current screen returns to the mode
screen after executing the format of the
USB device.
2. When you press the ❻ button,
the current screen returns to the mode
screen after canceling the format of the
USB device.
1) DDL-9000C-S
– 86 –