JUKI DDL-9000C-S - 8 How to Use the Operation Panel (Application); Setting up the Polygonal-Shape Stitching; Edit Method

– 78 –
8. HOW TO USE THE OPERATION PANEL (APPLICATION)
8-1. Setting up the polygonal-shape stitching
A polygonal-shape stitching pattern consists of
20 steps (at the maximum) of constant-dimen-
sion sewing patterns. Specic sewing conditions
can be set on a step-by-step basis.
<Example of pattern>
Step 5
Step 1
Step 2 Step 3
Step 4
8-1-1. Edit method
①
Displaying the polygonal-shape stitching pattern edit screen
Keep
❺
held pressed for one sec-
ond on the sewing screen which appears
when the polygonal-shape stitching is se-
lected. Then, the polygonal-shape stitch-
ing pattern edit screen is displayed.
<Sewing screen (Polygonal-shape stitching pattern)>
❺
<Polygonal-shape stitching pattern edit screen>
②
Selecting the step to edit
1. Select a step by pressing
❶
.
(The step that is being selected is dis-
played in reverse video.)
Step that is being selected
2. In the case there is an unused step(s), a step(s) can be added by following the procedure described
below. The step adding procedure is cancelled and the current screen is returned to the sewing
screen by pressing
❻
. (The step is displayed as a tentative step " " during the adding proce-
dure. The tentative step is conrmed as an added step by setting the number of stitches and pitch.)
❶ ❷
❽ ❻