JUKI SC-510 - Page 11

ENGLISH
– 9 –
* For handling the cable, refer to 14) and 15) of “6. Connecting the cords”.
1) Remove three screws
1
located on the side of
the control box.
2)
Set power source cover installing plate
2
sup-
plied with the unit as accessories to the control
box main unit with the three screws which have
been removed.
[ For LA specications only ]
10) Insert connector
6
coming from the motor to the
connector of the control box from the inside.
11) Securely x power source cover
7
supplied with
the unit as accessories to power source cover
installing plate
2
with two screws
8
supplied
with the unit as accessories while being careful
that the cord is not caught by the cover.
3)
Pass the terminal of the power source cord
through the hole from the inside of the power
source cover installing plate.
4)
After checking the direction of the nut
3
, pass
the nut through the power source cord supplied
with the unit as accessories and insert it into the
conduit.
(Caution) Note that the at face of the nut should
face the power source cover installing
plate side.
5) Securely x it to the installing ttings with nut
3
from both sides.
6
8
7
2
3
1