JUKI SC-510 - Page 19

ENGLISH
– 17 –
5
Thread trimming prohibition function setting
(Function setting No. 9)
Thread trimming operation at normal stitching
and overlapped stitching can be prohibited by
selecting the thread trimming prohibition.
Press / switch
1
to advance to the
function setting No. 9.
It is possible to change the set value with
switch
3
or switch
4
.
0 : Thread trimming is effective.
1
: Thread trimming is prohibited.
3
Number of stitches to stop the sewing machine
after detection of material end setting (Function
setting No. 4)
Press / switch
1
to advance to the
function setting No. 4.
It is possible to change the set value with
switch
3
or switch
4
.
Specied number of stitches : 0 to 19 stitches
(Caution) When the specied number of stitches is in-
sufcient, there is a case where the sewing
machine cannot stop within the specied
number of stitches depending on the speed
of rotation of the sewing machine.
4
One-shot automatic stitching setting function
(Function setting No. 76)
Press / switch
1
to advance to the
function setting No. 76.
It is possible to change the set value with
switch
3
or
switch
4
.
0 : Pedal designated speed is prior.
1
: Automatic operation
(Caution) It is rendered effective when the material
end sensor function is set.
It is not possible to prohibit the one-shot
operation at the time of the overlapped
stitching operation.
Speed of rotation is the speed set at the
function setting No. 38.
When "1" is selected, the one-
shot automatic stitching display
lights up when the mode is re-
turned to the normal one.
When "1" is selected, the thread
trimming prohibition display
lights up when the mode is re-
turned to the normal one.
1
3
4
1
3
4
1
3
4