JUKI SC-510 - Setting for Functions of SC-510

－
18
－
3. Setting for functions of SC-510
Functions can be selected and specied by means of the four setting switches and light emitting diode lo-
cated inside the front cover of the SC-510.
(Caution) • Do not perform switch operations other than those described in the following explanations.
• Be sure to re-turn the power switch ON after one second or more has passed. If the power is turned
ON immediately after turning it OFF, the sewing machine may not work normally. In this case, turn
ON the power again.
How to change over to the function setting modo
1) Turn OFF the power to the unit.
2) Pressing switch
4
, turn ON the power to the unit.
1
2
3
4
Specied value
Specied No.
3) Indication
5
,
6
will be shown on the display.
(If the indication fails to change, re-perform the
procedures 1) and 2).
3
Down switch (DOWN)
4
Up switch (UP)
1
Switch for entering specied value changed
and updating setting No. in DOWN direction
2
Switch for entering specied value changed
and updating setting No. in UP direction
4
6 5
4