– 26 –
2) Error code list (Error display in panel)
There are the following error codes in this device. These error codes interlock (or limit function) and inform the
problem so that the problem is not enlarged when any problem is discovered. When you request our service, please
confirm the error codes.
— UP position detection error when turn- .1. When needle position is not UP position at the 1. Set to UP position by turning handwheel by hand.
ing ON the power time of turning ON the power. 2. Connect synchronizer connector.
— Media cover open 1. Lid of media slot is open. Close the lid.
Execution of data initializationE000 1. EEPROM initialization is executed. —
2. Resistor pack is replaced.(Not error)
3. When machine head is replaced.
E003 Disconnection of synchronizer connector 1. When position detection signal is not inputted from 1. Check the synchronizer connector (CN30) for loose connection and disconnection.
the sewing machine head synchronizer.
2. When the synchronizer has broken. machine head or the like.
E005
Synchronizer upper position sensor failure
Overload of motorE007
E070
E071
E072
1. When the machine head is locked. 1. Check whether the thread has been entangled in the motor pulley.
2. When sewing extra-heavy material beyond the 2. Check the motor output connector (4P) for loose connection and disconnection.
guarantee of the machine head. 3. Check whether there is any draw when turning motor by hand.
3. When the motor does not run.
4. Motor or driver is broken.
Compact flash (TM) not insertedE011 Compact flash (TM) is not inserted. Return after reset operation.
Data read from compact flash (TM) is not possible.Read errorE012 Return after reset operation.
Data write to compact flash (TM) is not possible.Write errorE013 Return after reset operation.
Compact flash (TM) is in write prohibition state.Write protectE014 Return after reset operation.
Formatting cannot be performed.Format errorE015 Return after reset operation.
External media capacity overE016 Media capacity of compact flash (TM) is short. Return after reset operation.
Return after reset operation.File is too big.File size overE019
Abnormality of access of fileAccess errorE021 Return after reset operation.
File compatibility errorE032 There is not file compatibility.
Execution of panel backup dataE053 When model code of panel does not agree with that
initialization. (Not error) of control box.
When executing initialization operation when the panel.
Grease fill-up time informationE220 When grease fill-up time to the specified place has
When grease fill-up cannot be performed during sewing, release of error can become.
performed with the reset key of the panel.
Grease-up errorE221 LH-41** Machine head greasing alarm Replenish the specified grease and execute resetting operation.
(Grease replenishment alarm after the lapse of specified time)
Description of error detected.oN Item to be checked or corrective measureCause
E004
Synchronizer upper position sensor failure
2. Check whether the synchronizer cord has broken since the cord is caught in the
Turn OFF the power.
Turn OFF the power.
After turning OFF the power, perform grease fill-up, and set Function No.118 to “1”.
Slip of belt
1.
When the machine head is locked.
2.
Belt is loose.
1.
Check whether there is any holdup when turning the motor by hand.
2.
Check the belt tension.
Disconnection of motor output connector
Disconnection of motor connector Check the motor output connector for loose connection and disconnection.
Overload of motor at the time of thread
trimming motion
Same as E007 Same as E007
To Next Page
Loading...
