– 31 –
1. Press ON button
of the power switch to turn ON
the power.
(Caution) In case the power indication LED does
not lights up even when turning ON the
power switch,immediately turn OFF the
power and check the voltage.
In addition, in such a case as this, re-
turn ON the power switch when 2 to 3
minutes or more have passed after turn-
ing OFF the power switch.
2. When the needle bar is not in UP position, it automatically turns to the UP position.
(Caution) When turning ON the power for the first time, there is the case where the timing is slightly re-
tarded to perform the initialization work. When turning ON the power, the needle bar moves. Do
not put your hands or things under the needle.
3. When depressing front part
of the pedal, the
sewing machine rotates at the number of revolu-
tions in accordance with the depressing amount.
When the pedal is returned to the neutral posi-
tion, the sewing machine stops.
4. When lightly depressing back part
of the ped-
al, the presser goes up. (PFL type only)
5. When strongly depressing back part
of the
pedal, thread trimming is performed.
8. When sewing is completed, press OFF button
of
the power switch to turn OFF the power switch after
confirming that the sewing machine has stopped.
7. When pressing touch-back switch
, reverse
feed can be performed.
PFL KFL
Presser foot operation
by pedal
Enabled Disabled
Pedal depressing depth
for thread trimming
Deep Shallow
6. It is possible to program various sewing patterns,
using the operation panel, such as the reverse
feed stitching at sewing start and reverse feed
stitching at sewing end. Refer to
"5.-(4) Operat-
ing procedure of the sewing patterns"
for
details when using CP-18
. For the operation
panel other than CP-18
, refer to the Instruction
Manual for the operation panel to be used.
(2) Operating procedure of the sewing machine
To Next Page
Loading...
