JUKI SC-920 - Error Code List (SC-920)

– 64 –
No. Description of error detected Cause of occurrence expected Items to be checked
E000 Execution of data
initialization (This is not
the error.)
• When the machine head is changed.
• When the initialization operation is
executed
E003 D
isconnection of
synchronizer connector
• When position detection signal is not
input from the sewing machine head syn-
chronizer.
• When the synchronizer has broken.
• Belt is loose.
• Machine head is not proper.
• Motor pulley is not proper.
• Check the synchronizer connector (CN33)
for loose connection and disconnection.
• Check whether the synchronizer cord has
broken since the cord is caught in the ma
-
chine head.
• Check the belt tension.
• Check the setting of the machine head.
• Check the setting of the motor pulley.
E004 Synchron
izer lower
position sensor failure
E005 Synchronizer upper
position sensor failure
E007 Overload of motor • When the machine head is locked.
•
When sewing extra-heavy material
beyond the guarantee of the machine
head.
• When the motor does not run.
• Motor or driver is broken.
• Check whether the thread has been
entangled in the motor pulley.
• Check the motor output connector (4P) for
loose connection and disconnection.
• Check whether there is any holdup when
turning the motor by hand.
E070 Slip of belt • When the machine head is locked.
• Belt is loose.
• Check whether there is any holdup when
turning the motor by hand.
• Check the belt tension.
E071 Disconnection of motor
output connector
• Disconnection of motor connector • Check the motor output connector for loose
connection and disconnection.
E072
Overload of motor at the
time of thread trimming mo-
tion
• Same as E007 • Same as E007
E220
Grease-up warning • When the predetermined number of
stitches has been reached.
• Replenish the specified places with grease
and reset.
(For the details, refer to the data of the ma-
chine head.)
E221
Grease-up error • When the predetermined number of
stitches has been reached and the sew-
ing is not possible.
• Replenish the specified places with grease
and reset.
(For the details, refer to the data of the ma-
chine head.)
(1) Error code list (SC-920)