B
Dear Customer!
e assembly of your new house requires
a bit of technical knowledge. However, it is
important that the assembly instructions are
followed strict-ly. e assembly instruction
is a combination of text and illustrations. e
proles are packed in separate numbered packs
corresponding to the order in the assembly
instruction. Erect one pack at a time. All nuts
and bolts and ttings are found in bag No. 0
(specied on page 12). Each pack is specied in
separate lists of components.
All detailed illustrations are marked with
symbols:
Seen from inside Seen from outside.
Precautions.
• Assembly must only be carried out in dry
and calm weather.
• Always use working gloves while glazing.
Greenhouse glass has sharp edges,
especially if the glass breaks.
• Assistants and especially children must be
warned that broken glass is an element of
danger. Pick up broken glass at once and
remove it with care.
• We recommend to use protective glasses
while xing the spring wire clips.
• Place the ladder on a level support.
• It is essential to have an assistant.
References
e column marked indicates the
page(s) on which the component is used.
Page 13:
Foundation
e base is not included in this delivery.
However, an original base can be bought
separately. It ensures you a stable and easy to
build base.
If you make your own base the measurements
indicated must be external measurements.
If you buy an original base you furthermore
need about 75 litres of concrete and 6/8
plastic-/concrete pipes of about 800 mm which
are placed in a non-freezing depth for the
fastening of the corner and middle anchors.
e base must be 100% level and square; the
latter is ensured by checking that the two
diagonal measurements are equal.
Tools
e mounting of the greenhouse requires the
tools shown on page 12.
Page 14-27:
Place the components as shown on the
illustration and assemble in the order shown
in the pictures. Do not tighten the nuts
completely until the front gable construction
has been assembled.
Page 13:
(Fastening to the base).
When constructing your own base you have
to drill holes (7 mm) in the ground frame
between all the vertical frames, the greenhouse
is then fastened to the base with screws (A).
Using an original base the greenhouse is
fastened to each vertical bar as shown on
drawing B/C.
Page 24-27:
For an easier assembly we recommend that you
oil the screws for the doors.
Fitting of glass/polycarbonate
Important before glazing!
Make sure that gables and sides are level and
square, and that door(s) and window(s) are
functioning perfectly.
Best order of assembly:
1) Windows – 2) Roof – 3) Doors – 4) Gables
– 5) Sides
Page 30-33:
Glazing (illustration 1 to 8)
Degrease the sheets and frames with spirit.
Start glazing from below, one glass at a time.
Apply a 3 mm silicone line on the vertical
frames where indicated (dotted lines on
the illustration). (A 3 mm line of silicone is
sucient to obtain maximum attachment). If
you do use more than recommended, you can
buy extra tubes.
Spring wire clips and glassholders are to be
tted as shown.
X = Spring wire clips, > = Glassholders
In case of broken glass carefully pull it
outwards and loosen the silicone by means of a
sharp cra knife.
Clean the prole completely before inserting a
new pane of glass.
Page 34-37:
Mounting of polycarbonate
e illustrations at the bottom of page 34/36
show where to mount the polycarbonate plates
and lists. e type indication states the length
in mm. A possible adjustment is made by
means of a ne-tooth saw.
NB! To avoid the formation of algae the
polycarbonate sheets must not come into
contact with the ground. Rest them on a piece
of cardboard.
A-lists are mounted as shown on page 35/37.
Put the sheet into the bottom list, bend the
sheet slightly outwards and put it in the top list.
M-lists are mounted as shown on page 35/37.
Place the upper part of the list under the alu.
prole in the whole length of the sheet and
hereaer click on the list from above.
Sealing of the polycarbonate sheets
e sheets may be sealed against insects.
Close the top end o with alu-tape or silicone.
e bottom only with airstrip tape to let
condensation out (available at your local
dealer).
Now your greenhouse is completely assembled.
However, please notice the following:
Maintenance
• Grease doors (hinges and lock).
• Clean the gutter for leaves, etc.
• Adjustment of windows.
• Replacement of broken glass.
• Clean the house with disinfectant before
and aer the growing season.
Winter Protection
In areas with occurrence of snow we
recommend the following winter protection:
• Support the roof ridge at the centre of the
house.
• Remove greater snow loads from the roof.
• Take precautions against snow falling
down from for instance a tree or a roof.
• Dismount the cylinders for the automatic
window openers, if any (optional extras).
• Secure door(s) and window(s) preventing
wind damage to the house.
Insurance
Please note that not all insurance companies
cover glasshouses automatically. Please
contact your insurance company to ensure an
insurance coverage.
Guarantee
Juliana grants a guarantee of 12 years which
covers replacement of faulty parts. e
guarantee does not cover polycarbonate, glass,
transport, assembly, freight etc.
Juliana grants a guarantee of 2 years on painted
parts, if any. Note that marks in the painting
may occur due to suspension of the proles.
e guarantee is invalid if the greenhouse is
not assembled according to these instructions.
Complaints
All our greenhouses are built to high standards
of quality. However, should a complaint
occur please contact your dealer at once.
Remember to specify the defect by indicating
the greenhouse model and number of the
component and the quality control number.
May we congratulate you on your new greenhouse
GB USA
DEAR CUSTOMER
Congratulaons on purchasing your new
greenhouse. It is important that you follow these
assembly instrucons step-by-step.
The assembly instrucons are a combinaon of text
and illustraons. The proles are packed in separate,
numbered packs corresponding to their order of use
in the instrucons. Assemble one pack at a me.
All nuts, bolts and ngs are contained in bag No.
0 (specied on page 12). Each pack is specied in
separate lists of components.
All detailed illustraons are marked with the
following symbols:
Seen from the inside Seen from the outside
SOME SAFETY PRECAUTIONS
• Assembly must only be carried out in dry and
calm weather.
• Always wear work gloves when installing the
glazing. Greenhouse glass has sharp edges,
especially if it breaks.
• Assistants and especially children must be
warned that broken glass is dangerous. Pick
up all broken glass at once and remove it with
care.
• We recommend that you wear protecve
glasses while xing the spring wire clips.
• Any ladders that are used must be placed on a
level surface.
• It is essenal to have an assistant available.
PAGE 12: TOOLS
Assembling the greenhouse requires the tools
shown on page 12.
PAGE 13: FOUNDATIONS
No base is included with this product. However, an
original base is available separately. This base is easy
to construct and will guarantee you a stable base for
your greenhouse.
If you construct your own base, the specied
measurements must be external measurements.
If you purchase an original base, you will also require
about 75 litres of concrete and six to eight plasc/
concrete pipes of about 800mm. These pipes, which
must be buried at a sucient depth to ensure that
they do not freeze, secure the corner and middle
anchors.
The base must be completely level and square;
the laer can be ensured by checking that the two
diagonal measurements are equal.
ATTACHMENT TO THE BASE
If you construct your own base, you must drill holes
(7mm) in the ground frame between all the vercal
proles. The greenhouse must then be secured to
the base using screws (A).
If you use an original base, the greenhouse must be
secured to each vercal bar as shown on drawings
B/C.
Place the components as shown on the illustraon
and assemble in the order shown in the pictures. Do
not ghten the nuts fully unl the enre sub-frame
has been assembled.
For easier assembly, we recommend that you oil the
screws for the doors. The glass or polycarbonate for
the door(s) and windows must be ed at the same
me as the proles.
POLYCARBONATE
Important before assembly!
Make sure that the gables and sides are level
and square and that door(s) and window(s) are
funconing perfectly.
The best order of assembly for the glass or
polycarbonate is as follows:
Windows - Roof - Doors - Gables - Sides
Glass installaon (illustraons 1 to 8)
Degrease the sheets and frames with spirit.
Start glazing from the boom, one pane at a me.
Apply a 3mm silicone bead around the vercal
frames as indicated (the doed lines on the
illustraon). (A 3mm bead of silicone is sucient to
ensure maximum adhesion). If you use more silicone
than recommended, extra tubes can be purchased.
Spring wire clips and glass-holders must be ed as
shown.
X = Spring wire clips, > = Glass-holders
If you accidentally break a pane, carefully pull the
broken glass outwards and loosen the silicone using
a sharp cra knife.
Clean the prole completely before inserng a new
pane of glass.
The illustraons at the boom of pages 34/36 show
where to t the polycarbonate sheets and strips. The
type designaon states the length in millimetres. If
adjustment is necessary, use a ne-tooth saw.
NB! To avoid the growth of algae, prevent the
polycarbonate sheets from coming into contact with
the ground by resng them on a sheet of cardboard.
A-strips are ed as shown on pages 35/37. Insert
the sheet into the boom strip, bend the sheet
slightly outwards and insert it into the top strip.
M-strips are ed as shown on pages 35/37. Place
the upper part of the strip under the aluminium
prole along the full length of the sheet and then
click the strip into posion from above.
U-strips are ed as shown on pages 35/37.
Fit the strip to the sheet and adjust the length.
If desired, the sheets may be sealed against insects.
Seal the top using aluminium tape or silicone. The
boom should only be sealed with air-strip tape to
allow condensaon to escape (available from your
local dealer).
Your greenhouse is now fully assembled. However,
please note the following:
MAINTENANCE
• Grease the doors (hinges and locks).
• Keep the guers free from leaves, etc.
• Adjust the windows as necessary.
• Replace any broken glass.
• Clean the greenhouse with disinfectant before
and aer the growing season.
If you ancipate snow during the winter, we
recommend the following winter precauons:
• Support the apex of the roof in the middle.
• Remove any deep snow from the roof.
• Take precauons to prevent snow falling from
a tree or roof, for example.
• Remove the cylinders for the automac
window openers, if ed (oponal extras).
• Secure the door(s) and window(s) to prevent
wind damage to the greenhouse.
Please note that your greenhouse is not like a
conservatory, for example, and that you should
therefore be aware that the greenhouse may leak
during or aer precipitaon and that condensaon
will occur on the inside of the greenhouse. Good
venlaon will help prevent condensaon.
INSURANCE
Please note that not all insurance companies cover
greenhouses automacally. Please contact your
insurance company to ensure that your greenhouse
is covered.
GUARANTEE
Juliana greenhouses are covered by a 12-year
guarantee, which covers the replacement or repair
of faulty parts. The guarantee does not cover
polycarbonate, glass, transport, assembly, freight,
etc.
Juliana greenhouses are covered by a two-year
warranty on painted parts, where ed. Note that
marks on the paint may occur due to suspension of
the proles.
The guarantee will be void if the greenhouse is not
assembled in accordance with these instrucons.
COMPLAINTS
All our greenhouses are built to the highest quality
standards. However, should you experience any
problems, please contact your dealer at once. When
describing the defect, please state the greenhouse
model, the component number and the quality
control number.
Any suspension marks or shiny ends on painted
Juliana proles will not be visible aer the
greenhouse has been assembled.
Congratulaons on your new greenhouse, which we
hope will bring you a lot of pleasure for many years
to come.
Yours sincerely,
Juliana Drivhuse A/S
To Next Page
Loading...
