10
4 Operation
4.1 Display
(1) Display of the measured value unit
(2) Warning signal:
In case of low battery or recalibration request
(3) Temperature coefficient configuration unit
(4) Subsidiary display/subsidiary measured value:
Temperature measured value
(5) Display of the selected temperature compensation
(6) Display elements for the appearance of the minimum (MIN),
maximum (MAX), or saved measured value (HLD)
a
a
The "DIF" display is not supported in this device.
(7) Main display/main measured value:
Conductivity (mS/cm, µS/cm)
specific electrical resistivity (k
Ω
cm)
TDS/filtrate dry residue (mg/l)
Salinity (SAL)
To Next Page
Loading...
