117
8 Operation
8.6 Operation of the data monitor/recording function
The standard version of the JUMO AQUIS touch P is equipped with a data mon-
itor. It is used to record and view the analog measuring value and signal states
of digital functions. Two groups are available, each of which can record up to 4
analog values and 3 binary values and display them in the form of a line recorder
diagram. There is a separate diagram for each group in the operation loop.
The recording function represents an Add-On to the data monitor and is
available as an extra code.
⇨ Chapter 4.2 "Order Details", page 22
The features of the data monitor and recording function are listed in the
following table:
Data monitor Recording
Measured-data recording
Recording of the measuring values from up to 4
analog channels and display of the measuring
values in the form of a line recorder diagram
XX
Digital data recording
Recording of the binary values from up to 3 digital
channels and display of the digital data in the
form of a binary channel
XX
Displaying events
Event list entries are shown as icons in the line
recorder diagram
XX
History function
For scrolling the line recorder
diagram to the past to view measurement data
and events from farther back in time
X
Zoom function
The time range is compressed to view
measured-data histories over longer periods in
one area of the screen
X
Measurement data retrieval
for archiving recorded measurement data and
evaluating the data via
JUMO PCC/PCA3000
X
To Next Page
Loading...
