10 Configuration
134
10.2 Basic settings
Open: Device Menu > Configuration > Basic Settings
Configuration point Selection/
setting option
Explanation
Device name up to 20 text characters Device ID, e.g. for identification of exported mea-
surement data in the JUMO PCA 3000 evalua-
tion software
National language German
English
Setting the operating language
Additional languages can be installed on the de-
vice using the setup program.
⇨ Chapter 22.8.4 "Country settings", page 316
Language select after
power on
Yes
No
Specifies whether a prompt for selecting the op-
erating language should appear when the device
is switched on
Mains frequency 50 Hz
60 Hz
Supply frequency of the electric power grid serv-
ing the mounting site
The supply frequency must be specified to sup-
press EMC interference caused by the mains
voltage. Setting the correct supply frequency is
thus also necessary when supplying the device
with direct voltage.
Device temp. Degrees Celsius
Degrees Fahrenheit
Setting the default on the temperature unit for all
temperature values in the device
Interface temperature Degrees Celsius
Degrees Fahrenheit
Setting the default on the temperature unit for all
temperature values communicated via interfaces
Memory alarm limit 0 to 100 % If the available memory display reaches this val-
ue, the memory alarm is triggered.
The following settings can be edited only with the aid of the JUMO PC setup program
Setup quick info up to 20 text
characters
Brief information text about setup
Setup info up to 501 text
characters
Detailed information text about setup
Version
online-visualization
No online-vis.
Standard online-vis.
Selection of a saved online-visualization
Online-visualization permits remote control of the
operation screens via a web browser
⇨ Chapter 8.7 "Online visualization", page 122
When the webserver is active on the device,
the website of the webserver is displayed in the
web browser instead of the online-visualization.
⇨ Chapter 22.8.13 "Web server", page 352
To Next Page
Loading...
