155
10 Configuration
10.8 Digital outputs of base unit and optional boards
Open: Device Menu > Configuration > Digital Outputs >
Digital Output 1 to 17
Configuration point Selection/
setting option
Explanation
Designation up to 21 text characters Designation for the output
Signal
output value
Selection from
binary selector
Digital signal source for the output
Inversion Yes
No
Invert/do not invert state
Enable manu. mode Yes
No
The manual mode for the specific output is en-
abled/locked here.
Manual mode permits fixed binary values
(switching states) to be set for the output for test-
ing purposes.
⇨ Chapter 8.2.3 "Functional level", page 91
To Next Page
Loading...
