JUMO AQUIS touch P - Page 169

167
10 Configuration
JUMO digiLine pH
Alarm Explanation
pH sensor alarm Alarm for pH value out of range
Temperature sensor alarm Alarm for temperature out of range
pH min. warning Lower pH limit value pre-alarm from sensor (see "Sensor
monitoring" in the JUMO digiLine pH operating manual)
pH min. alarm Lower pH limit value alarm from sensor (see "Sensor
monitoring" in the JUMO digiLine pH operating manual)
pH max. warning Upper pH limit value pre-alarm from sensor (see "Sensor
monitoring" in the JUMO digiLine pH operating manual)
pH max. alarm Upper pH limit value alarm from sensor (see "Sensor
monitoring" in the JUMO digiLine pH operating manual)
Min. temperature warning Lower temperature limit value pre-alarm from sensor (see
"Sensor monitoring" in the JUMO digiLine pH operating
manual)
Min. temperature alarm Lower temperature limit value alarm from sensor (see
"Sensor monitoring" in the JUMO digiLine pH operating
manual)
Max. temperature warning Upper temperature limit value pre-alarm from sensor (see
"Sensor monitoring" in the JUMO digiLine pH operating
manual)
Max. temperature alarm Upper temperature limit value alarm from sensor (see
"Sensor monitoring" in the JUMO digiLine pH operating
manual)
Calibration timer alarm Alarm for sensor calibration due (see "Calibration data" in
the JUMO digiLine pH operating manual)
CIP/SIP/Autoclaving warning Pre-alarm for maximum number of CIP/SIP/autoclaving
cycles (see "Sensor monitoring" in the JUMO digiLine pH
operating manual)
CIP/SIP/Autoclaving alarm Alarm for maximum number of CIP/SIP/autoclaving cy-
cles (see "Sensor monitoring" in the JUMO digiLine pH
operating manual)
Sensor stress warning Sensor stress pre-alarm (see "Sensor monitoring" in the
JUMO digiLine pH operating manual)
Sensor stress alarm Sensor stress alarm (see "Sensor monitoring" in the
JUMO digiLine pH operating manual)
Digital input state Signal state of the digital input of the sensor electronics