10 Configuration
182
10.14 Setpoint value configuration
Open: Device Menu > Configuration > Setpoint Value Configuration > Setpoint
Value Configuration Controller 1 to 4
Configuration point Selection/
setting option
Explanation
external
Setpoint 1 to 2
Selection from
Analog selector
Selection of the analog value as setpoint value
source
If external setpoint values 1 to 2 are selected,
they replace setpoint values 1 to 2 of the
controller parameters in the respective control-
lers.
⇨ Chapter 9.2 "Parameter Sets (Controller pa-
rameter)", page 128
With external setpoint values, the "Manual entry"
button
on the controller screen is hidden.
⇨ Chapter 8.5.1 "Automatic control mode", page
112
Signal
Setpoint changeover
Selection from
binary selector
Digital signal for switching from setpoint value 1
to
Setpoint value 2
Binary value = 0 activates (external) setpoint val-
ue 1
Binary value = 1 activates (external) setpoint val-
ue 2
Start
Setpoint value limit
-99999 to +99999 lower limit for setpoint values
End
Setpoint value limit
-99999 to +99999 upper limit for setpoint values
To Next Page
Loading...
