185
10 Configuration
Timing diagram
10.15.1 Control timer
Timer settings for a timed program during the week
Prerequisite: The "Timer function" must be configured as a "Control timer" or
"Control timer with runtime".
⇨ Chapter 10.15 "Timer", page 183
Up to 4 Switch-on and Switch-off times can be specified separately for each
weekday.
Open Switching Time Settings: Device Menu > Configuration > Timers >
Timer 1 to 12 > Control Timer > Monday to Sunday
Timer start
delay
Timer time After-run time
Timer end
After-run time
Timer end
t
t
Signal
Timer start
Output
signal
Timer start
delay
Timer time
t
After-run time
Timer
Configuration point Selection/
setting option
Explanation
Switch-on times 1 to 4 hh:mm:ss When the time passes the On-time, the
control timer sets the binary value = 1 (switched
on).
Switch-off times 1 to 4 hh:mm:ss only for "Control timer" (without runtime):
When the time passes the Switch-off time, the
control timer sets the binary value = 0 (switched
off).
Runtime hh:mm:ss only for "Control timer with runtime":
Time during which the control timer with runtime
has a binary value = 1 after the switch-on time;
After the "Runtime" elapses, the binary value
changes back to 0.
To Next Page
Loading...
