10 Configuration
192
10.21 Logic formula
Logic formula are created with the JUMO PC setup program and loaded
to the device. Following this, the configuration of a logic formula can also be ed-
ited
directly on the device.
Open: Device Menu > Configuration > Logic Formula > Formula 1 to 30
10.22 Manual values (configuration)
Open: Device menu > Configuration > Manual Values (config.) > Manual
Value (config.) 1 to 16
Configuration point Selection/
setting option
Explanation
Designation up to 20 text characters Logic formula designation
Alarm type Corresponding notifications for the alarm/event list can be
configured for logic formulas
.
The alarm settings for all digital device functions are explained together.
⇨ Chapter 10.11.3 "Digital signal alarms", page 173
Alarm/Event list
Alarm text
Alarm delay
Digital signal for hold
Response at hold
Configuration point Selection/
setting option
Explanation
Designation up to 20 text characters Designation of the manual value
Temperature None
Relative
Absolute
For automatic conversion of temperature units, it
is necessary to know whether the manual value
is an absolute temperature
(temperature value on the Celsius scale) or a rel-
ative temperature (temperature difference in
°C). If the manual value not a temperature,
"none" must be set here.
Unit up to 5 text characters Entry of the unit for temperatures
inactive:
Unit for the manual value
Decimal place Auto
Fixed comma format
Decimal points in the display
Start
Display range
-99999 to +99999
a
Upper/lower limit for labeling the scale
when displaying measuring values, e.g. in re-
corder
diagrams and bar graphs
End
Display range
-99999 to +99999
a
a
The unit set for the particular manual value appears in the entry field.
To Next Page
Loading...
