247
18 Calibrating universal inputs
18.2.2 Universal inputs calibration default settings
The calibration default setting available for selection depends on the configura-
tion settings of the universal input.
Open the calibration default settings:
Device Menu
r Calibration r Select Universal Input r
Calibration Default Settings
Calibration default settings for the individual operation modes
• linear scaling
The calibration default settings enable the calibration routines to be accessed in
the particular calibration menu.
Calibration routines that are not enabled are not visible in the calibration menu.
The "linear scaling" operation mode permits adjustment of the zero point, slope,
and two-point calibration.
• pH value measurement
The calibration default settings correspond to those for the zero-point and two-
point calibration for pH/Redox/NH
3
analysis inputs.
v „pH calibration default settings“, Page 213
• Conductivity measurement
The calibration default settings correspond to those for the Ci calibration.
v Chapter 17.2.2 "Calibration default settings for Ci conductivity sensors", Page
236
Sample screen:
Universal input calibra-
tion default settings in
the "linear scaling"
operation mode
To Next Page
Loading...
