249
18 Calibrating universal inputs
18.3 Universal input calibration routines
This chapter explains the universal inputs calibration routines for the "linear scal-
ing" and "free chlorine, ph/T-compensated" operation modes.
The explanations in the corresponding calibration chapters for the "pH value
measurement" and "Conductivity measurement" operation modes apply, except
that three-point calibration for pH sensors is not available for universal inputs
(see Chapter 18.2.1 "Calibration methods for universal inputs", Page 245).
v Chapter 13.3 "pH Calibration routines", Page 215
v Chapter 17.3 "Ci calibration routines", Page 239
NOTE!
You must be logged in with corresponding user rights to perform calibrations.
v Chapter 8.2.1 "Log-on/Log-out", Page 89
To Next Page
Loading...
