JUMO AQUIS touch P - Accessories

25
4 Identifying the device version
4.4 Accessories
Order code Type Part no.
703571 (20258x)/10 Universal input 00581159
703571 (20258x)/213 Activation of the recording function 00581176
703571 (20258x)/214 Activate math and logic module 00581177
703571 (20258x)/11 Binary output relay (changeover contact) 00581160
703571 (20258x)/12 Binary outputs 2× relay (normally open contact) 00581162
703571 (20258x)/13 Solid state relay triac 230 V, 1 A 00581164
703571 (20258x)/14 Logic output 0/22 V 00581165
703571 (20258x)/15 2 Logic outputs 0/12 V 00581168
703571 (20258x)/16 analog output 00581169
703571 (20258x)/17 Digital outputs 2× solid state relay PhotoMOS®
a
00581171
703571 (20258x)/54 Serial interface RS422/485 for Modbus RTU and
JUMO digiLine
b
00581172
703571 (20258x)/64 PROFIBUS-DP 00581173
703571 (20258x)/08 Ethernet 00581174
20258x/3 Analysis input Ci for inductive conductivity 00584265
20258x/2 Analysis input CR for resistive conductivity 00584263
20258x/1 Analysis input pH/Redox/NH
3
00584264
20258x/18 Digital inputs 3× potential-free contact 00592962
20258x/19 Voltage supply output DC ±5 V, 24 V 00592963
USB flash drive 2.0 (2 GB)
c
00505592
USB cable, A-connector to Mini-B connector,
length 3 m
00506252
JUMO PC setup program AQUIS touch S/P,
(PG202599)
00594355
JUMO PCA3000/PCC software package
d
00431884
Surface-mounted case for JUMO AQUIS touch P 00628452
a
PhotoMOS® is a registered trademark of Panasonic.
b
The accessories required to install a JUMO digiLine bus can be found in the type sheets and operating
manual for the JUMO digiLine components (e.g. JUMO digiLine pH/ORP/T type 202705 or JUMO dig-
iLine hub type 203590).
c
The USB flash drive indicated has been tested and is designed for industrial applications. No
liability is assumed for flash drives from other manufacturers.
d
Communication and evaluation software for stored recording function measurement data