277
22 PC Setup Program
22.1 General information
All configuration data and parameterization can be edited offline with the JUMO
PC setup program. Entire device configurations can be loaded into the device,
exported from the device and saved on a PC/laptop.
In addition, the software is needed for the following tasks:
• Editing of User names and user rights on the device
⇨ Chapter 22.8.3 "User list", page 313
• Saving and deleting languages from the device
⇨ Chapter 22.8.4 "Country settings", page 316
• Creating/editing device settings lists for user levels
⇨ Chapter 22.8.6 "User levels", page 324
• Creating/editing formula and logic formula
⇨ Chapter 22.8.7 "Formula", page 325
⇨ Chapter 22.8.8 "Logic formula", page 326
• Creating/editing value tables for customer-specific linearization
⇨ Chapter 22.8.9 "Customer-specific linearization", page 327
• Editing of Buffer set tables for automatic buffer detection when calibrating pH
sensors
⇨ Chapter 22.8.10 "Buffer set tables", page 330
• Creating/editing Process screens
⇨ Chapter 22.8.11 "Process screens", page 331
• Configuring the e-mail function
⇨ Chapter 22.8.12 "Email", page 345
• Configuring the Webserver
⇨ Chapter 22.8.13 "Web server", page 352
• Viewing calibration logbooks
⇨ Chapter 22.9.1 "Calibration logbooks", page 354
NOTE
Data transmission from and to the device requires that the following require-
ments be satisfied:
• The device must be powered on
• The device must be connected to the PC either via USB or Ethernet (see
Chapter 22.7 "Connection to device", page 298)
• All windows on the user interface of the device must be closed; the device
must be at the operating level
Configuration or parameter changes may not be made simultaneously on the
device and with the JUMO PC setup program.
To Next Page
Loading...
