291
22 PC Setup Program
22.6 Menu bar
This chapter describes the menu bar functions. The order of the subchapters
corresponds to the location of the menus in the menu bar (from left to right).
22.6.1 File menu
New
Creates a new setup file in the working area. After selecting the "New" com-
mand, the user can select from the following options:
• User-Defined Setting
Extra codes and optional boards can be selected for the new setup file. This
option is used to create a new setup without having a device connected.
• Automatic Detection
The configuration (extra codes and optional boards) of the connected device
are written to the new setup file. If desired, the "Read setup file from device"
checkbox can also be selected. The current configuration is then written to
the new setup file from the device and is available for editing.
This option is used to edit or create the setup for an existing or new device.
Open ...
Opens an existing setup file and displays the content in the working area.
Save
Saves the settings shown in the work area in a setup file. The file name must
only be entered once. If the file is saved again, the file name is no longer re-
quested.
Save as ...
Saves the settings shown in the work area in a setup file. In contrast to the
"Save"
function, a prompt for the file name always appears in this case.
Close
Removes the settings shown in the working range from the working range and
closes the Setup window. The user has the opportunity to save changes that
have not yet been saved.
Export as RTF
Saves the current setting as an RTF file on the PC.
This function is useful for documenting a device configuration.
Print ...
Prints the setup settings of the project or module (depending on the item high-
lighted in the navigation tree). The menus to be printed can be selected before-
hand.
To Next Page
Loading...
